Rear

Remove rear wheel.

After finishing work: Bleed brake system.





Apply pedal support and press brake pedal slightly. This prevents brake fluid from escaping from the expansion tank after the brake lines have been opened (which would enable air to enter the brake system).





Release screws (1).

Disconnect brake hose (2).

Unfasten brake hose on connection point to brake line.

Right side:

Disconnect plug connection for brake lining sensor.

Pull off fist caliper towards rear of vehicle.

Installation:
Install brake hose without torsional stress. First tighten the brake hose on the brake cover, then tighten connection on brake line.

Tightening torque, screws (1): Refer to Specifications.

Tightening torque for brake hose/line: Refer to Specifications.

Caution: Check routing and securing of brake-pad-wear indicator cable.

Check for correct securing with tab of dust cap.

Rubbing of cable on rim must be prevented.