Front Door Airbag Module

WARNING: Review Service Precautions. Improper handling could cause activation of the airbag(s) and lead to injuries! Service Precautions

- Removing and installing front left or right door trim.





- Unfasten plug connection for side airbag from bracket.





- Open plug connection for side airbag by applying pressure to tab and unfasten connector.





- Unfasten screws and remove airbag module.

CAUTION: Always replace micro-encapsulated screws!

- Tightening torque: 11 Nm

NOTE: Modified airbag modules will be used.

The Differences Are:
- Modified retaining tab.
- Integrated lead with airbag plug.





Previous Version:
- 4 retaining tabs (1).
- Without fitted lead and airbag plug, adapter lead required.





- 3 retaining tabs (1).
- Without fitted lead and (2), adapter lead omitted.

NOTE: If an airbag module with 4 retaining tabs is replaced with an airbag module with 3 retaining tabs, it is necessary to observe the following: the adapter lead is omitted (lead is firmly attached to airbag module), remove the nut retainer for the 4th retaining screw (risk of rattling noises), touch up any damage to paint, seal the opening in the sound insulation for the 4th retaining screw that is no longer required so as to prevent moisture from entering the door trim panel.