Headlamp Washer Spray Nozzle: Adjustments

Adjusting Spray Nozzles For Headlight Cleaning System

Special tools required:
- 00 9 100
- 64 1 020







Low-beam headlamp:
The spray contact point must be located in the center of the low-beam headlamp.
To adjust, slowly pull out spray nozzle fully with aid of special tool 64 1 020 and adjust spray contact point with special tool 00 9 100







High-beam headlamp:
The spray contact point must be located in the center of the high-beam headlamp.
To adjust, slowly pull out spray nozzle fully with aid of special tool 64 1 020 and adjust spray contact point with special tool 00 9 100


NOTE:
After checking the contact points, turn ignition off and on again before repeating the spray procedure. The function of the headlight cleaning system is otherwise disabled for approx. 3 minutes. Refer to function description in Diagnosis and Information System.