"2 Exchange Control Module"

Programming Procedures For "2 Exchange Control Module"

Select this to program a replacement Basic DME control module.

Prior to any type of programming, make sure the DME fault memory is cleared and vehicle battery is fully charged!

1. From the function selection menu select "2 Exchange Control Module" and press the enter button.
2. Press the right arrow button.
3. Press "1 Determine Basic Control Module" and press the enter button.
4. Press Y to confirm control module is still in car.
5. Turn on ignition and press the Y button to start the automatic determination.
6. If chassis numbers compare press the Y button. If they are different press the N button and enter it manually.
7. The MoDiC provides the replacement control module part numbers in the display. The part number on the left is for a new control module. The number on the right is for a remanufactured control module. Always order the remanufactured number.
8. Obtain the control module and install in the car. The vehicle data will remain stored in the MoDiC as long as it is not used for any other purpose. Press the up arrow to return to the selection menu.
9. Select "Program control module" and press the enter button.
10. Enter the last 7 digits of the VIN and press the Y button.
11. Press the Y button to start automatic programming.
12. The MoDiC will display when the programming is complete.