Removing and Installing or Replacing Airbag Unit

WARNING!
Conform with safety precautions!
Incorrect handling can activate airbag and result in injury.
Disconnect battery and cover negative pole or terminal.







Airbag I and basic/central airbag unit:
Unscrew screw.
Pull lower section of steering-column casing off upper section

Installation:
Check for correct position of lock.







Pull (orange) plug-in connection out of holder on steering column and disconnect.







Remove screws (Torx T 30 socket).

Installation:
First tighten screws on right-hand side in forward direction.
Do not pinch wires.
Tightening Torque = 8 Nm







Pull off connector and remove airbag unit.


CAUTION!
Lay airbag unit to one side (in luggage compartment). padded side must always face upwards.







Airbag II:


CAUTION!
If a fault has been detected in airbag system (airbag indicator light illuminates), a 10-minute waiting period must be observed after disconnecting battery Capacity in control unit is discharged and a trigger pulse cannot be generated inadvertently.
Loosen screws (1).


Installation:
Tightening Torque = 2 Nm.







Pull off connector and remove airbag unit.

Installation:
Secure airbag unit in steering wheel. Do not pinch wires.







WARNING!
Lay airbag unit to one side (in luggage compartment) padded side must always face upwards.