Dismantling and Reassembling

(cylinder head removed)





Screw special tool 11 0 213 to special tool 11 1 065.





Secure special tool 11 1 065 to special tool 00 1 490.
Provide special tools for disassembly of cylinder head:
- Special tool 11 1 071
- Special tool 11 1 067
- Special tool 11 0 192





- Special tool 11 1 045
- Special tool 11 0 345
- Special tool 11 0 342
- Special tool 11 0343
- Special tool 11 0211





Note: At this point, do not yet install special tool 11 0 211 (support board) in special tool 11 1 065.
Remove throttle assembly.

Caution: The work step Removing and installing throttle assembly contains important tips on installing the pull rods and the throttles, refer to Powertrain Management.





Unfasten screws.
Remove water pipe (1).





Installation:
Replace gaskets (1).





Caution: Do not damage sealing surface.
If necessary, cover special tool 11 1 065 with plastic sheeting.
Fit cylinder head on special tool 11 1 065 and secure with two cylinder head screws.
Remove camshafts.
This task is described in "Removing left/right camshafts", refer to Camshaft, Lifters and Push Rods.
Remove all valve springs.
Remove all valve stem seals.
Remove all valves.