Without Steptronic

Remove/Replacing Shift Tower
Without Steptronic

Move selector lever to "P" (PARK) position.

Remove transmission underbody protection if necessary.





Brace clamping piece (1) and slacken nut (2).

Installation:
Adjust selector lever.





Brace cable at hexagon (1) and release nut (2).

Pull cable out of holder.





Note: Do not turn handle when pulling off as this would shear off the turning lock in the handle.

Pull off handle with a forceful tug.

Installation:
Attach handle to selector lever.
Align handle and press on until it can be felt snapping into place.





Pull trim (1) out of center console.





Disconnect cable plug.





Installation:
Adjusting display slide of trim:
^ Press band (1) a little to one side.
^ Press adjuster (2) of display slide (3) against stop (4).
^ Position opening of trim (5) over opening of display slide (3).
^ Move preselector lever to "N" (NORMAL) position.
^ Insert trim on preselector lever and install.
^ Move preselector lever to T" (PARK) position.
^ Display slide (3) is now adjusted.





Release screws.





Lever trim (1) out of center console, disconnect cable plugs (2 ... 3) and remove trim (1).





Remove storage tray (1).





Release screws.





Pull support member (1) slightly out of center console.

Depending on equipment, press fitted switches (2) forwards out of support member (1) and disconnect.

On rear side of support member (1), disconnect cable plug from cigarette lighter and ashtray light.

Remove support member (1).





Detach cable plug from fixture and disconnect.





Release screw (1) and remove interlock cable (2) from interlock lever (3).

Installation:
Adjust interlock cable and check interlock operation.





Release screws and remove shift tower with cable.