Removing Heater Blower
Removing Heater Blower
Turn toggle (1) through approx. 90° and remove cover (2) towards front.
Remove microfilter element (1).
Unclip retainers (1) and feed cable out of cable duct.
Release screws (1) and remove microfilter housing towards front.
Installation:
Seals on microfilter housing must not be damaged or missing.
Detach rubber strip (1)
Release locks (2) and pull side trim forwards a little.
Remove screws (1) and (2).
Lift out heater bulkhead.
Release screws and lever out cover for blower impeller.
Release screw (1), disconnect plug connection (2) and lever out blower resistor.
Installation:
First install resistor. Then insert plug connection.