Transmitter Self-Test

Transmitter Self-Test












Pressing buttons #1 and #3 at the same time will start a self-test of the transmitter. The transmitter is OK when the LED comes on steady for one second. If the LED fails to come on, try replacing the batteries before discarding the transmitter.

The state of charge of the transmitter batteries is monitored by the control module. Once the voltage level of the transmitter drops below 4.5 volts, the LED will no longer signal transmitter operation. Convenience opening, initialization and self-testing are no longer possible. The control module will store the low battery level and post a message in the check control display will the door is opened.


NOTE: Replacing the batteries within one minute will not require a new initialization procedure.