Installing Replacement Transmission (S5D 280Z)

After completion of work, check transmission oil level.

Caution: Use only the approved gear oil in this manual transmission.

Failure to comply with this requirement will result in serious damage to the transmission.

Remove transmission.

Fit following parts from old transmission on the new transmission:

Release bearing and release lever.

Threaded pin for slave cylinder.

Reversing light switch.

Tightening torque, refer to Specifications.





Convert shift rod joint.
Push retaining ring (1) back and drive out straight pin (2).

Installation:





Check damping disk (6) in joint for damage and replace if necessary.





Detach breather (1) and protective sleeve (2) from selector shaft.

Lever out sealing flap (3) and breather (1).