25 11 111 Replacing Shift Rod Joint

25 11 111 Replacing Shift Rod Joint

Transmission removed.




Detach locking clamp.

Important!
New retaining clips fitted as from 04.08




Retaining clip must interlock captively with retaining web (1) behind shift rod pin.




Pull shift rod (1) out of shift rod joint (2) and remove shims (3).

Installation:
- Grease shift rod pin (4).
- Grease, use only BMW approved: Kluber Polylob GLY 801

Large contact surface of disks (3) must rest on shift rod joint (2).




Lever spring washer (1) out of groove and push a little towards rear.

Press dowel pin (2) upwards/downwards out of shift rod joint and remove shift rod joint.

Installation:



- Grease ball of transmission selector shaft.
- Grease, use only BMW approved: Kluber Polylob GLY 801
- Replace spring washer (1).

Installation:
- Check rubber ring (1) in shift rod joint (2) and replace if necessary.