25 11 211 Replacing Shift Arm For Shift-Lever Mount

25 11 211 Replacing Shift Arm for Shift-Lever Mount


Necessary Preliminary Tasks:
- Remove shift lever, please refer to:
- Support transmission with hydraulic lifter.




Release screws and remove crossmember (1).

Tightening torque:




Release screws on propeller shaft center mount (1).

Lower transmission.




Use a screwdriver to lift out spring (1) from the lug (2) on the housing and swivel upwards.




Remove bearing pin (1).

Installation:
- Grease bearing pins (1).
- Grease, use only BMW approved: Kluber Polylob GLY 801

NOTE:
Do not remove support bearing (1).




Do not remove shift arm (2) from support bearing (1).

Installation:
- Grease bearing pin of shaft arm.
- Grease, use only BMW approved: Kluber Polylob GLY 801

NOTE:



If bearing bush is damaged: replace bearing bush.

Press out bearing bush.

Coat new bearing bush with Circolight -83 19 9 407 771-.and then press into shift arm until side flanges of bearing bush protrude uniformly.