Tightening Specifications

Tightening Specifications
Transmission To Engine:
Hex Screws:
M8 25 Nm
M10 49 Nm
M12 74 Nm
Torx Bolts:
M8 22 Nm
M10 43 Nm
M12 73 Nm
Transmission Crossmember To:
Rubber Mounts 74 Nm
Body 41 Nm
Universal Joint To Rear Propeller Shaft And Transmission (Steel Propeller Shaft);
M10 8.8 49 Nm
M10 10.9 64 Nm
M12 10.9 100 Nm
Driveshaft To Drive Flange (Rear Axle):
Universal Joint Version
Compression Nut 64 Nm
Finned Nut:
M8 43 Nm
M10 70 Nm
Torx Bolt 85 Nm
Constant Veloicty Joint Version
Compression Nut 32 Nm
Finned Nut:
M8 43 Nm
M10 70 Nm
Center Mount To Body 21 Nm
Slave Cylinder To Clutch Housing Or Transmission Case 22 Nm
Reversing Light Switch 18 Nm
Cover With Guide Tube To Transmission Case:
M8 x 22 18 Nm
M8 x 30 25 Nm
M6 10 Nm
Output Shaft Flange Collar Nut (Installed with Bolt Cement)
1st Step Pretension to 190 Nm
2nd Step Release
3rd Step Tighten to 120 Nm