Procedure 2

Remove Or Replacing Control Unit





The control unit for EGS is located in the engine compartment on the right-hand side wall.

Raise engine hood.

Interrogate and print fault memory prior to removal.

Version with insulating cover:

Unscrew insulating cover from separating wall.





Unscrew cover.





Press EGS control unit down off of spring retainers (1 and 2).





Pull out control unit forward through the opening.





Installation:
Place control unit on left and right rails and slide in inclined upwards as far as stop.
In this position swing the control unit upwards and engage it in spring retainers (1 and 2).





Pull plug (1) off of control unit after swinging spring retainer (2) forward.

Caution: Always switch ignition off before disconnecting or connecting connector.





Code is on identification plate.
Refer to BMW Parts Catalog for cross reference of types and models.