Removing and Installing Selector Lever With Mounting Block

Remove Selector Lever With Mounting Block





Remove fillister head screw (internal hexagon 3 mm).

Pull off handle with pull rod.

Installation:





Button not pressed.

Attach pin (1) of button in bore hole (2) of pull rod.





Remove clock or on-board display. Remove panel at bottom.





Remove cover for selector lever.

Pull plug (3) on EGS switch and indicator light (4).

Installation:





Adjusting display slide of trim:
- Press adjuster (1) of display slide (2) against stop (3).
- Position opening of trim (4) over opening of display slide (2).
- Move preselector lever to "N. (NORMAL) position.
- Insert trim on preselector lever and install.
- Move preselector lever to "P" (PARK) position.
- Display slide (2) is now adjusted.





Pull plug (6).

Lever out retainer (7).

Remove cable from counter support and detach towards front.

Unhook cable from eye.





Installation:
Insert turning lock with bore hole in nubs.
Mount cable in this position.





Remove retaining screws.
Tightening torque, 2516 3AZ.





Tilt mounting block and remove towards top.

Installation:





Installation position of seal between mounting block and body.
1 Seal
2 Adapter
3 Seal

Check that seals are still usable, replace if necessary.

Check cable adjustment, readjust if necessary.