Selector Lever With Mounting Block

Remove Selector Lever With Mounting Block - Version With Interlock/Shiftlock





Remove fillister head screw (internal hexagon 3 mm).

Pull off handle with pull rod.

Installation:





Button not pressed.

Attach pin (1) of button in bore hole (2) of pull rod.





Remove clock or on-board display.

Remove panel at bottom.





Remove trim for selector lever.

Pull plug (3) on EGS switch and indicator light (4).

Installation:





Adjusting display slide of trim:
- Press adjuster (1) of display slide (2) against stop (3).
- Position opening of trim (4) over opening of display slide (2).
- Move preselector lever to "N. (NORMAL) position.
- Insert trim on preselector lever and install.
- Move preselector lever to "P" (PARK) position.
- Display slide (2) is now adjusted.





Pull plug (6).

Lever out retainer (7).

Remove cable from counter support and detach towards front.

Unhook cable from eye.

Installation:





Insert turning lock with bore hole in nubs.

Mount cable in this position.





Release screw (1).





Remove holder.

Unhook interlock cable.

Installation:
Adjust interlock cable.





Replace interlock cable.





Disconnect plug connection for shift lock.





Release retaining screws.
Tightening torque, 25 16 3AZ.





Remove shift tower and seal.

Installation:
Check that seals are still usable, replace if necessary.

Adjust shifting.





Assembly and adjustment of interlock cable:

Move selector lever to P position (foremost position).





Attach cable eyelet to lever journal.





Fit cable with holder and screw on bearing shell. The cable must remain easily movable axially in the holder.





Turn ignition key to zero position.

Remove ignition key.





Check interlock/shiftlock function.

Press locking lever downwards and tighten down screw for cable mounting.
Tightening torque8 Nm.





Check interlock/shiftlock function.