Removing and Installing/Replacing Lid on Rear Storage Box

51 16 239 Removing And Installing/Replacing Lid On Rear Storage Box

Necessary preliminary tasks:
- If necessary, remove eject box from storage box lid







Open lid (1) and release screws (2) on bearing (3).







NOTE:
- Wire (3) of dia. 1.9 mm and approx. 60 mm in length is required.

Open lid (1) approx. 150 mm.
Slide wire (3) into bore (2) and release







IMPORTANT
- Risk of damage.
- Lid (3) must neither be completely open nor opened further. Wire (4) must remain in lid (2).

In this position, unclip lid (3) with bearings (2) in direction of arrow out of mountings (1).
If necessary, disconnect plug connections from additional equipment.







Installation:
Do not pull out wire (4).
If necessary, turn shaft at square with open-end wrench upwards slightly and slide wire (4) into bore.
If necessary, replace defective bearings (2).
Attach left/right bearings (2) correctly to shaft (1).
Opening on bearing (2) points downwards slightly.
Tighten screws (5) after fitting lid to specified torque.
13AZ Flap to storage box 0.5 Nm