Removing and Installing Complete Exhaust System

Removing And Installing Complete Exhaust System (M54)

Special tools required:
^ 31 2 220

Warning!
Scalding hazard!
Only perform this work after engine has cooled down.





Support exhaust system with jack and special tool 31 2 220 and secure against falling out.





Lift out expansion rivet (1).

Release screws and remove heat shield (2).





Release nuts (1) and remove connecting plate (2).

Installation:
Replace self-locking nuts.
Coat threads with copper paste, refer to BMW Parts Service.





Installation:
Replace both seals (1).

Important! Removal of exhaust system must be carried out with assistance of a second person.





Note: The reinforcement plate (1) is connected via rubber mounts to the exhaust system and can remain on the exhaust system during removal.

Release screws on reinforcement plate (1).

Release screws and remove body reinforcement strut (2).

Release nuts on rubber mount of rear muffler (3) on left and right.

Lower exhaust system with lifter and remove.