Installing Exchange Transmission (S6S 420G)

Drain off gear oil from old transmission. Catch and dispose of emerging gear oil.

Recycling:
Observe country-specific waste-disposal regulations.

Caution: After 2000 km it is absolutely essential to carry out a breaking-in inspection including an oil change, refer to Specifications

Transmission must be filled with Lifetime oil.

Remove transmission.

Convert following components of old transmission to new transmission:
^ Release bearing and release lever
^ Dowel pin for slave cylinder
^ Reversing light switch. Tightening torque, refer to Specifications.
^ Retainers for oxygen sensor cable
^ Transmission breather cap (in ace with sticker on transmission)





Convert shift rod joint.

Slide back snap ring (1) and drive out dowel pin (2).





Note: Check damping disk (6) for damage and replace if necessary.