Removing and Installing/Replacing Airbag Module on Left or Right Rear Door

72 12 015 - Removing and installing/replacing airbag module on left or right rear door





Warning!
Read and comply with safety regulations [1][2]Safety Regulations for Handling Components with Gas Generators for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.





Necessary preliminary tasks:
- Disconnect battery negative lead Disconnecting and Connecting Battery Negative Lead
Follow instructions for disconnecting and connecting battery Instructions for Disconnecting and Connecting Battery.
- Remove rear door trim Removing and Installing Left or Right Rear Door Trim Panel





Release screw (1).
Release nuts (2) and remove holder (3).

Installation Note:
Tightening torque: 72 12 01AZ Airbag Modules.
Coat nut and thread with paint (any color and type can be chosen).





Fold back tabs (1) of plastic housing and remove airbag module (2) from airbag mounting.

Installation Note:
There must be no foreign objects (e.g. screws, nuts etc.) in the airbag mounting in the door trim panel.





Important!
There must be no foreign bodies (e.g. screws, nuts, etc.) in the airbag mounting (1).





Installation Note:
Slots (2) of holder (1) must be positioned over threaded pins (3).
Point angled part of holder (1) to door trim panel.