Body - Window Moves Only in Small Increments

SI B61 10 02
General Electrical Systems

October 2002
Service Engineering

SUBJECT
Window Initialization Procedure

MODEL
B65, E66 (7 Series)

SITUATION
After replacement of a door module the window only moves in small increments and does not have toll functions.

CAUSE
Window needs to be initialized.

PROCEDURE

1. After door module has been installed, program/code as per SI B09 05 01.

2. Make sure that window to be initialized is in the full open position.

3. Close the door of the window that needs to be initialized.

4. Press and hold the window switch all the way down for approximately 17 seconds.

5. Lift switch and hold up.

6. Window will move up through its full travel, then down and back up again.

7. Test function of toll feature.

WARRANTY INFORMATION
For information only.