Steering Angle Sensor: Service and Repair

Removing and installing or replacing steering angle sensor

Caution: The steering angle sensor must be coded if it has been replaced. A steering angle offset for Electronic Damper Control/Dynamic Stability Control must then be carried out.

Remove lower trim from instrument panel.





Remove clamping bolt.

Lock steering wheel.

Press down on steering spindle.

Installation:
Clamping screw must be located in retaining groove of upper steering spindle.

Replace self-locking nut.

Tightening torque, refer to Specifications.

To illustrate more clearly, operation is shown on a removed steering column.





Detach steering angle sensor from steering spindle.

Installation:
Pin of pivot mounting (1) must rest in square section (2) of steering angle sensor.