Rear Bumper Reinforcement: Service and Repair

51 12 051 Removing And Installing/Replacing Carrier For Rear Bumper Trim (M3, M3 CSL / Lightweight Design)

NOTE: Refer to KSD CD for details of preliminary tasks.

IMPORTANT: Foam part must be replaced when center section of bumper (carrier) is removed.







Drill out blind rivet (1) and remove grounding cable (2).







Release plastic screws (1).

Installation:
Observe tightening torque 1.2 Nm.

Release metal screws (2).
Remove center section of bumper (carrier) (3).







Release plastic screws (1).

Installation:
Observe tightening torque 1.2 Nm.

Remove foam part (2).