Plug System D1.5/D2.5

Plug System D1.5/D2.5

Circular Plug 7-8 Pin System D2.5







- Pull off the rubber boot (1).
- Push the retaining lugs (2) of the inner connector section 3 inward carefully to disengage the lock notch.







- Push the inner connector section (3) in the direction of the arrow in the illustration until the retaining lugs (2) are in the recessed notch (4) and use the appropriate sized spring contact tool and remove the connector from the housing.

Circular plug 13 Pin System D2.5







- Carefully pull off the rubber grommet (1).
- Pull the lock retainers (2) outward (direction of arrows) to allow the lock notch to disengage.







- Pull the inner section (3) upward as shown in the illustration until the lock notches (4) are in the released position of the lock retainers (5) and use the appropriate size spring contact and remove the connector from the housing.

Circular Plug 20 Pin System D2.5







- With the boot pulled back, press the lock tabs (1) of the inner connector section (2) inward.







- Simultaneously, rotate the inner connection section (2) counter clockwise to allow the lock tabs (1) to engage in the unlocked position and use the appropriate sized spring contact and remove connector from the housing.

Circular Plug 4-7-10-12-25 Pin System D1.5/D2.5







- Insert the appropriate unlocking tool (determined by the number of pins) into the connector.







- The connector is unlocked when the lock tab (3) is in the unlocked position (1). The connector is locked when the lock tab (3) is in the locked position (2).
- Use the appropriate sized spring contact and remove connector from the housing.

In-line Plug 15 Pin System D2.5







- Pull the outer connector section (1) slightly outward in the area of lock tabs (2).







- Simultaneously, slide the inner connector section (3) in the direction of the arrow to the unlocked position.
- Use the appropriate sized spring contact and remove connector from housing.

In-line Plug 8-, 12 Pin System D2.5







- Slide the upper section (1) and the lower section (2) of the connector in opposite directions to unlock the connector.







- Using special tool 61 1 132 press the spring latch down and pull the connector (3) from the housing.

In-line Plug 20 Pin System D2.5







- Pull locking slide (1) completely out of connector (2).







- Using special tool 61 1 132 press the spring latch down and pull the connector from the housing.

In-line Plug 30 Pin System D2.5







- Pull the outer section (1) slightly outward in the area of lock tabs (2).







- Simultaneously, slide the inner connector section (3) in the direction of the arrow to the unlocked position.
- Use the appropriate sized spring contact and remove connector from housing.