Antitheft and Alarm Systems: Service and Repair

61 35 015 - Removing and installing/replacing control unit for Car Access System





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Necessary preliminary tasks:
- Remove trim panel for pedal assembly 51 45 185 Removing and Installing/Replacing Panel For Pedals.





Unfasten plug connection (2) and disconnect.

Important!
Carefully unlock and disconnect associated plug connection for ribbon cable (1).
Replace ribbon cable (1) if
- plug connection for ribbon cable (1) is damaged
- control unit for Car Access System (3) is replaced
The ribbon cable leads to the ignition starter switch Removal and Replacement.

Release screw (4) and remove control unit for Car Access System (3) in direction of arrow.





Installation Note:
Feed guide (1) of control unit for Car Access System (2) correctly into associated mounting.





Replacement:
Carry out programming/coding Programming and Relearning.
Version with independent heating:
Initialize all independent heating remote controls Testing and Inspection.