Installing Replacement Transmission (GS6-37BZ/DZ)

23 00 036 - Installing replacement transmission (GS6-37BZ/DZ)





Important!
After completion of work, check transmission fluid level Procedures.
Use only the approved transmission fluid.

Failure to comply with this instruction will result in serious damage to the transmission.





Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations





Necessary preliminary tasks:
- Drain gear oil at oil drain plug. Tightening torque:23 00 4AZ. Transmission in General

- Remove transmission. Removing and Installing Transmission (GS6-37BZ)





Convert following parts from previous transmission to new transmission.
- Release bearing and release lever. Service and Repair

- Ball pin and spring wire clip.

- Studs for clutch slave cylinder.

- Reversing light switch tightening torque: 23 41 5AZ [1][2]Automatically Shifted Manual Transmission/Transaxle.





Release screws.
Remove and convert transmission bearing block.
Tightening torque 23 71 3AZ/ 4AZ 23 71 Transmission Mounts.

Note:
Illustrations show E60.





Convert shift rod joint.
Push back retaining ring (1) and drive out dowel pin (2).





Note:
Check damping disk (6) for damage and replace if necessary.





Add final details to vehicle.
Check oil level.

Installation Note:
Observe greasing specification Removing and Installing Transmission (GS6-37BZ).