Wiper Motor: Service and Repair

61 61 270 - Removing and installing console for windshield wiper system completely with motor





Necessary preliminary tasks:
- Remove cowl panel cover Service and Repair.
- Remove tension strut on spring strut dome Service and Repair.
- Remove fresh air duct Service and Repair.





Important!
Before fitting windshield wiper arms, allow wiper motor to run into rest position.





Release screws (1).

Installation:
Tightening torque 61 61 15AZ 61 61 Windshield Wipers.

Remove cross-strut bearing block (2) in direction of arrow.





Unfasten plug connection (1) and disconnect.
Release screws (A5...A1).

Installation:
Insert screws (A1...A5) in specified sequence until hand-tight.
To tighten down screw (A2), if necessary move complete wiper console linkage (2) into reversal position.
Tighten down screws (A1...A5) in specified sequence to tightening torque 61 61 6AZ 61 61 Windshield Wipers.

Lever out complete wiper console (2) in direction of arrow.