Removing and Installing/Replacing Control Unit for Backrest Width Adjustment

61 35 076 - Removing and installing/replacing control unit for backrest width adjustment





Special tools required:
- 52 0 050 52 0 050 Pliers





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Necessary preliminary tasks:
- Remove switch combination for seat adjustment





Unclip cover (1) on front seat.





Release screws (1) on thigh support.

Disconnect plug connection (2).

Remove thigh support (3) towards top.

Installation Note:
Insert screws (1) with Loctite.





Unclip trim (1) for thigh support carrier.





Detach seat cover (1).

Tilt back seat cover (1) with padding towards middle of vehicle.





Loosen retainers (1).

Tilt back thigh support (2) towards rear.

Remove all remnants of clips from seat cover and seat mechanism.

Installation Note:
Bend new retainers closed with pliers 52 0 050 52 0 050 Pliers.





Release screw (1) under tilted-up seat padding.

Unlock plug connections (2) and disconnect.

Remove control unit for backrest width adjustment (3) towards bottom.





Replacement:

Carry out programming/coding Programming and Relearning.