Blower Motor: Service and Repair

64 11 213 - Removing and installing/replacing heater - A/C unit fan





Necessary preliminary tasks:
- Remove storage compartment 51 16 200 Removing and Installing Storage Compartment.
- Remove audio system controller Removing and Installing/Replacing Audio System Controller /
Car Communication Computer Removing and Installing/Replacing Car Communication Computer.
- Remove trim panel for pedal assembly 51 45 185 Removing and Installing/Replacing Panel For Pedals.
- Remove right glovebox with housing 51 16 366 Removing and Installing Right Glovebox With Housing.





Disconnect rear compartment air duct (1) in direction of arrow.

Installation:
Make sure rear compartment air duct (1) is correctly seated.





Release screws (1).
Remove middle function carrier (2) in direction of arrow.

Installation:
Make sure middle function carrier (2) is correctly seated.
Ensure correct cable routing.





Necessary preliminary tasks:
- If necessary, remove temperature sensor for cold-air distributor Service and Repair.

Unfasten plug connection (1) and disconnect.

Release clips (2).
Unfasten plug connection (3) and disconnect.
Remove rear compartment air duct (4) in direction of arrow.

Installation:
Make sure rear compartment air duct (4) is correctly seated.





Disconnect left air duct (1) in direction of arrow (2) and (3).

Installation:
Make sure right air duct (1) is correctly seated.





Disconnect right air duct (1) in direction of arrow (2) and (3).

Installation:
Make sure right air duct (1) is correctly seated.





Unlock plug (1) and remove.
Release screws (2).
Remove cover (3) in direction of arrow.

Installation:
Ensure correct cable routing.
Make sure seal is correctly seated in cover (3).





Release screws (1).
Remove fan for heater - A/C unit (2) in direction of arrow.

Installation:
Make sure fan for heater - A/C unit (2) is correctly seated.





Replacement:
Unlock controller for heater - A/C unit fan (1) with a suitable screwdriver (2) and remove.
Unlock plug connections (3) and disconnect.

Installation:
Make sure controller for heater - A/C unit fan (1) is correctly seated.