Operation CHARM: Car repair manuals for everyone.

Rear

34 52 535 Replacing a rear pulse generator

Necessary preliminary tasks:
^ Remove rear wheel.
^ Read and comply with General Information.

Observe safety instructions on raising the vehicle.





Open connector housing (1), pull plug connector (2) out of bracket and disconnect.
Pull cable out of brackets on swinging arm.

Installation:
Ensure proper locking of the plug connector and proper seating of the cable in the brackets.





Release hexagon socket head cap screw (1), pull wheel speed sensor out of bore.

Installation:
Tightening torque, 34 51 6AZ; Pulse generator to swivel bearing/wheel carrier 8 Nm.
Clean hole for impulse sensor and grease with lubricating grease Staburags NBU 12/K .