Procedures

37 14 51 Replacing front ride-height sensor





Note:
^ Build date up to 3/4: Variant (A) - connection (1) points downwards
^ Build date from 3/4: Variant (B) - connection (2) points upwards

Build date up to 3/4:

Important! If the front ride-height sensor has been installed twisted in relation to variant (A), e.g. due to wiring harness replacement, the following control units must be recoded.
^ Light module with headlight vertical aim control
^ Adaptive headlight

Necessary preliminary tasks:
^ If necessary, remove steering gear cover at side

After installation:
^ Check headlight adjustment, correct if necessary





Shown on build date up to 3/4:
Unscrew nut (1).
Tightening torque; Control rod to ride height sensor/bracket / control arm 8 Nm
Disengage control rod.
Release screws (2).
Tightening torque; Ride level sensor to holder 5 Nm
Remove ride-height sensor from holder.
Unlock plug (3) and remove.

Installation:
Build date up to 3/4: If necessary, tie back connecting cable for ride-height sensor.