Wheel Alignment

Wheel Alignment
If the vehicle requires a wheel alignment, the initialization procedure must be started before beginning the alignment. Using the DlSplus/GT1, complete the following steps:
^ Access the test module for Start-up adjustment/AFS. When prompted, answer Yes to the alignment question.
^ Center steering rack and check alignment marks on the steering gear
^ Install tool # 324150 and lock steering wheel
^ Proceed with alignment
^ After completing the last steps of the alignment (front toe adj), remove 324150.
^ Proceed with the remaining portion of the test module.
This will set the total steering angle to 0 degrees by locking the superimposing gear (ring gear). The AFS control module will deenergize the electromagnetic lock which will hold the AFS actuator motor which will in turn hold the superimposing gear stationary. If alignment is attempted without performing this procedure, the steering will be off center by a considerable amount. Special tool # 324150 is used to hold the steering wheel in the center position. Failure to use the special tool will result in an off center steering wheel.