Operation CHARM: Car repair manuals for everyone.

Dynamic Drive Control Unit

Dynamic Drive Control Unit
The Dynamic Drive control unit is located on the right side of the passenger compartment in the A pillar area.
The control unit is supplied with power via terminal 30 and is protected by a 10 A fuse.
A vehicle authentication process takes place when the system is started. This compares the vehicle identification number from CAS with the vehicle identification number which is encoded in the Dynamic Drive control unit.
Then the control unit hardware and software is checked.
All the outputs (valve magnets) are subjected to a complex check for short circuits and breaks. If there is a fault, the system switches the actuators into a safe driving condition.
The control unit switches off if there is undervoltage or overvoltage.
The control unit learns the offset for the steering angle and the lateral acceleration during start-up and during driving.