Replacing Vent Hose For Active Stabilizer (Front)

37 10 005 Removing and installing/replacing vent hose for active stabilizer (front)

Necessary preliminary tasks:
^ Remove front underbody protection

After installation:
^ Carry out initial DYNAMIC DRIVE operation.





Distribution hose:
Release nuts (1).
Tightening torque 5 Nm
Withdraw vent line (3) from distribution hose (2).
Remove distribution hose (2).





Vent hose:
Withdraw seal plug (1) from front axle carrier.
Remove vent line with filter from front axle carrier.





Observe the following when replacing vent valves:
Release vent valves (1).

Installation:
Push distribution hose (2) into vent valves (1) up to middle between markings (M).
Tightening torque 14 Nm
Screw vent valves (1) completely into oscillating motor.
Remove assembly plugs from both vent valves (1).