Removing and Installing/Replacing Lower Section of Steering Spindle

32 31 070 - Removing and installing / replacing lower section of steering spindle





Important!
If the lower section of the steering spindle is separated from the power steering gear/steering column, the steering column switch cluster may be damaged when the steering wheel is turned.





If necessary, remove steering gear cover at side.
Release clamping screw.
Remove lower section of steering spindle from power steering gear.

Installation Note:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Lower section of steering spindle can only be attached in one position to the power steering gear.
Clamping screw must rest in groove of power steering gear.
Tightening torque 32 31 1AZ [1][2]Specifications.





Important!
Make sure universal joint is correctly seated.





Remove trim panel for pedal assembly 51 45 185 Removing and Installing/Replacing Panel For Pedals.
When reinstalling lower section of steering spindle: mark installation position of universal joint in relation to steering column.
Switch on ignition.
Turn steering wheel approx. 45°, hold securely and release clamping screw (1).
Turn steering wheel back and remove ignition key.
Remove lower section of steering spindle from steering column.

Installation Note:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove of steering column.
Tightening torque 32 31 1AZ [1][2]Specifications.





After installation:
- Turn steering wheel in both directions to full lock. The airbag warning lamp must not light up in the process.
- Carry out steering angle sensor adjustment/adjustment for active front steering
- Check directional stability of car