Procedure

To reprogram DME control module:

1. Connect vehicle to the BMW approved battery charger.

2. Connect DISplus/GT1 loaded with CD38.0 or higher.

3. Select: BMW Coding/Programming.

4. Select: 5 Programming, then right arrow.

5. Select: 3 DME Programming, then right arrow.

6. Display appears First determine and then program basic control unit, then right arrow.

7. Select: 1 Determine basic control unit, then right arrow. Automatic determination is going to be performed.

8. DME, is the faulty control unit still installed in the car? Select YES.

9. Start automatic determination? Select YES.

10. Display appears: Compare chassis number displayed with number in the car. Chassis number ..... Do numbers correspond? Select YES.

11. Part number basic control unit ...../..... are displayed, then scroll down.

12. Display appears: Followed part numbers (basic control unit) can likewise be use. A new program version is also programmed for these part numbers. Duration depends on control unit between 4 - 16 minutes, then scroll down.

13. At this point, vehicle data is stored in the tester for the automatic identification. Disregard the screen prompt which refers to obtaining and installing a new basic control unit. Scroll to the left.

14. Select: 2 Exchange control unit, then right arrow.

15. Select: 2 Program basic control module, then right arrow.

16. Follow instruction: Chassis number, enter the last 7 characters of VIN. Is the number correct? Select YES.

17. Disregard the next instruction: Install new basic control module, just go forward by pressing right arrow.

18. Display will appear: There is new program version and new data version for this control unit. Depending on the control unit, programming may last between 4-16 minutes. First programming and then data are programmed. After programming, with diagnosis program, the fault memories have to be cleared. EWS alignment is automatically carried-out with reprogramming. The adaptation values must be cleared after programming, then right arrow. The next screen displays: The control module can be programmed X times, then right arrow.

19. Follow the command: Please enter reading mileage ..... Entry correct?. Select: YES

20. Start automatic programming? Select: YES

21. When programming starts, the following message is displayed: Program programming active. Voltage terminal 30 .....

22. After programming part is finished, the following message is displayed: Data programming active. Voltage terminal 30.....

23. After successful programming, message is displayed: Programming terminated.

24. Next, follow screen instructions for EWS alignment, clearing of adaptation values, and for printing new DME label.