Replacing Mounting Bracket For Windshield Wiper System

Removing And Installing Mounting Bracket For Windshield Wiper System Completely With Motor

Special tools required:
- 61 6 250

Remove cover for cowl.







Pull out air funnel (1) on microfilter housing.







Remove screws (1) and (2).

Installation:
If necessary, replace damping ring upper/lower section.
Tighten screws (1) and (2) in specified sequence.
Observe tightening torque.
6AZ Wiper bracket to firewall
E53 10 Nm
Note: If necessary, observe tightening sequence

Release nut (3) with special tool 61 6 250.

Installation:
If necessary, replace rubber buffer.
Fit nut (3) loosely.

Remove bracket for windshield wiper system (4) and disconnect plug connection (5).

Installation:
Before installing wiper arms, allow wiper motor to return to its rest position.
To ensure the wiper system works properly, check and correct the contact angle of the wiper arms.







In event of deviations from specified value, correct contact angle using adjusting screw (1).
Check contact angle of wiper arms again.
Grip adjusting screw (1) and tighten nut (2) with special tool 61 6 250.
Observe tightening torque.
6AZ Wiper bracket to firewall
E53 10 Nm
Note: If necessary, observe tightening sequence

Secure nut (2) with locking varnish.