Replacing Rear Window Wiper Motor
Removing And Installing/Replacing Rear Window Wiper Motor
Remove panel for rear lid upper section at bottom.
Remove wiper arm for rear wiper.
NOTE: Secure rear window wiper motor against falling out.
Disconnect plug connection (1) and release screws (2).
Remove rear window wiper motor (3).
Installation:
Insert screws (2) and tighten until hand-tight.
Center rear window wiper motor (3) and tighten down screws (2).
Observe tightening torque.
1AZ Wiper bracket to rear lid
E53
M6 10 Nm
Installation:
Replace rubber grommet (1).
Note installation position of rubber grommet (1) (marking must be in horizontal position).