Removing and Installing/Replacing Tension Belts

54 31 150 Removing And Installing/Replacing Tension Belts

Necessary preliminary tasks:
- Remove convertible top
- Partially remove convertible top fabric (without main support and without last bow)







Feeding out belt at bow 1:
- Release screws (1) on left/right on inside
- Retract convertible top a little
- Pull belt slightly and retract fastening clip
- Feed out start of belt to center over opening (2) towards top







Unfasten screws on left/right side.

Installation:
Fit belt first at bow 1 to obtain tension. Then insert screw here.

Unfasten screws on left/right side.







Installation:
Guide belt clip from rear over last bow.







Feeding belt out of convertible top strip:
- Raise welt
- Remove welt towards rear bottom







Feed out cable towards bottom.







Unfasten screws.
Feed out belt.







Installation:
Pay attention to right (1) and left (2) version.

3 = Rear