11 00 670 Securing Engine In Installation Position (M54)

11 00 670 - Securing engine in installation position (M54)





Special tools required:
- 00 0 200
- 00 0 202
- 00 0 204
- 00 0 208
- 11 0 020





Warning!
Danger of injury!

Observe following instructions relating to special tool:
1. Prior to each use, check the special tools for defects, modifications and operational reliability.
2. Damaged/modified special tools must not be used!
3. No changes or modifications may be made to the special tools!
4. Keep special tools dry, clean and free of grease.





Necessary preliminary tasks:
- Secure engine bonnet/hood in service position
- Remove engine cover
- Place wiring harness on rear of cylinder head to one side, cut through cable tie if necessary





Assemble cross member 00 0 200 with special tools 00 0 202, 00 0 204, 00 0 208.
Modification:
Replace profile strips with special tools 00 0 451





Important!
Avoid a change of engine position in the transverse or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its attachment parts) and the body.





Important!
Risk of damage!

With the aid of an assistant and the supports, place cross member 00 0 200 on the screw connections of the side panels.

Secure special tool 11 0 020 with the off-centre hole to spindle 00 0 202.
Fit suitable chains to special tool 11 0 020 and attach to both engine lifting eyes (1).





Warning!
Danger of injury!

Tighten down all adjusting screws and nuts on cross member 00 0 200.





Unscrew nuts (1).

Raise engine approx. 10 mm with cross member.

Installation Note:
Replace self-locking nuts.

Tightening torque 22 11 2AZ .