Removing and Installing/ Replacing Left B-Pillar Sensor (Build Date Up to 12/2005)
Removing and Installing/ Replacing Left B-Pillar Sensor (Build Date Up to 12/2005Warning!
Note airbag safety instructions!
Incorrect handling can activate airbag and cause injury.
Necessary Preliminary Tasks:
- Disconnect battery negative lead and cover, Service and Repair.
- Remove front left entrance cover strip, Service and Repair.
- Remove rear left lower side trim section, Service and Repair.
Unlock plug connections (1) and disconnect.
Release screws (2) and remove B-Pillar sensor (3) in direction of arrow.
Installation:
- Tightening Torque, 65 77 5AZ.
Replacement:
Carry out coding/ programming.
Observe following IDC specifications:
- Programming
- Coding
- Car & Key Memory
- CD "CIP"