Operation CHARM: Car repair manuals for everyone.

Coupe



54 12 003 Adjusting Glass Slide/Tilt Sunroof Lid

Special tools required:
- 00 9 315

Close glass sunroof lid (zero position).







Ideal adjustment:
- Distance:
- Distance (A) between lid and front and rear of roof must be the same.
- Slide a credit card or identity card in between seal and lid. The card must show the same resistance.

- Height:
- Front - flush to 1 mm deeper
- Rear - flush to 1 mm higher







Adjustment/removal of glass slide/tilt sunroof lid:
Slowly slide headliner (floating) towards rear up to distance (A).
Measurement (A) = 90 mm.







Slacken screws (1) on left/right.

NOTE:
- For adjustment, only slacken screws (1) to such an extent that glass sunroof lid (2) is still just adjustable.
- To remove glass sunroof lid (2), release screws (1) completely.







Height adjustment:
Adjust height of lid (1) to roof (2) with special tool 00 9 315 (gap wedge).
Press glass sunroof lid at front and rear upwards/downwards until ideal position is obtained.

Distance adjustment:
- Slide glass sunroof lid forwards/back until ideal position is obtained.
- Tighten down screws.
2AZ (Glass) cover to gate Always use new nuts and bolts. 4.5 Nm
- Check function and adjustment.







Replace screws (1) when removing and installing glass sunroof lid (2).

Installation:
2AZ (Glass) cover to gate Always use new nuts and bolts. 4.5 Nm

Installation:
Initialize sunroof.







Slowly pull headliner (floating) fully towards front.