Turn Signals: Service and Repair

Removing And Installing/Replacing Complete Front Left Or Right Turn Signal Lamp

Up to 09/2001:







Open hood.
Press down retainer (1) through bore in side panel and slide turn signal lamp towards front.







Installation Note: Make sure bonded rubber seal (1) is correctly seated on trim (2).

From 09/2001:







Open hood.
Loosen screw (1).


NOTE: Secure front turn signal lamp (2) against falling out.


Slide out front turn signal lamp (2) in direct of arrow.







Installation Note:
Make sure nut (1) is correctly seated on headlight housing (2).
If necessary, when screwing front turn signal lamp into place, secure nut (1) with screwdriver (3) against turning.







Installation Note:
When sliding in front turn signal lamp (1), make sure guides (2) are correctly seated in mountings of headlight (3).
Make sure bonded seal is correctly seated under front turn signal lamp (1).

All:







Disconnect plug connection (1).


NOTE:
Turn signal lamp, front left:
To release, turn bulb holder (2) clockwise.
Turn signal lamp, front right:
To release, turn bulb holder (2) counterclockwise.
Turn bulb holder (2) and remove turn signal lamp (3).


Installation Note: Make sure seal is correctly seated between bulb holder (2) and turn signal lamp (3).