Removing and Installing/Replacing Both Tension Struts

31 12 080 - Removing and installing/replacing both tension struts





Important!
Observe safety instructions on raising the vehicle 00 .. ... Lifting Vehicle With A Lifting Platform.





Necessary preliminary tasks:
- Remove front assembly underside protection Removing and Installing/Replacing Front Underbody Protection
- Remove air duct for brake ventilation
- E67: Remove spring strut





Build date up to 09/03:
Remove tension strut cover.

Installation Note:
Attach tension strut cover over bolt head and nut. Pin (1) must snap into place in bore (2).





Release nut (1) and remove screw.

Installation Note:
Replace self-locking nuts.
Tighten bolt connection in normal position Moving Vehicle Into Normal Position.
Tightening torque 31 12 1AZ Control Arms and Struts (Front).

Release nut (2); if necessary, grip at Torx socket.

Installation Note:
Keep tension strut to swivel bearing connection clean and free from oil and grease.
Replace self-locking nut.
Tightening torque 31 12 19AZ Control Arms and Struts (Front).