Removing and Installing/Replacing Drive Unit for Roller Sun Blind

67 65 010 - Removing and installing or replacing drive unit for roller sun blind





Necessary preliminary tasks:
- Remove roller sun blind (refer to "Removing and installing/replacing trim for parcel shelf 51 46 001 Removing and Installing Panel For Rear Window Shelf (Parcel Shelf)")





Release screw (1).
Remove drive linkage (2).
Mark installation position of servodrive on bracket (3).

Installation:
Ensure correct cable routing.





Note:
Do not damage electrical lead for roller sun blind drive unit when drilling.

Arrange bores according to dimensions (A - D) and release screws underneath for roller sun blind drive unit.

Remove roller sun blind drive unit.
Dimensions from reference line (1):
A = 155 mm
B = 60 mm
C = 60 mm
D = 30 mm





Note:
Drive linkage (2) can only be installed in one position.

Installation:
Install drive linkage (2) and insert screw (1).
Secure drive unit to bracket (3).
Tighten screw (1).