Replacing Rear Glass Slide/Tilt Sunroof Cover

Removing And Installing Rear Glass Slide/Tilt Sunroof Cover

NOTE:
The following steps can be carried out inside the vehicle with the glass roof panel fully closed.
Open floating roofliner fully.
Make sure that grease at the ends of the rail do not come into contact with the roofliner.

Not necessary for replacement:
Before removing the Torx screws, make a mark around the washers in order to ensure correct alignment during installation.







Remove and dispose of the Torx screws (1) securing the glass panel to the mechanism.

Installation:
Insert new Torx screws and align washers to markings.
Tightening torque.
2AZ (Glass) cover to gate 6 Nm
Always use new nuts and bolts.







IMPORTANT: A second person is required to help in removing and installing the glass slide/tilt sunroof lid.

Lift out glass slide/tilt sunroof cover (1).

Installation:
Tape off installation area on left and right at roof aperture with fabric adhesive tape.
Install glass slide/tilt sunroof cover carefully (twist in) as seal can be damaged during installation.
Check glass slide/tilt sunroof cover for correct alignment and adjust if necessary.