Replacing Servomotor For Left Eccentric Shaft

Removing And Installing/Replacing Servomotor For Left Eccentric Shaft (N62)

(Cylinder Bank 5 to 8)

Remove acoustic cover.

Remove ignition coil cover.





Unlock plug (1) on servomotor (2) and disconnect.





Unfasten screws.

Rotate servomotor (2) until no longer engaged in spline teeth of eccentric shaft.





Installation:
Replace sealing ring on spacer.

Install servomotor (1) and screw in up to spacer.

Rotate servomotor (1 ) into correct installation position.

Install and tighten down screws.

Installation:
Read out fault memory of control unit of Digital Motor Electronics (DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.