32 21 151 Replacing Left or Right Tie Rod

32 21 151 Replacing left or right track rod end







NOTE: If the track rod end to track rod screw connection is released, it is necessary after reinstallation to carry out a chassis / wheel alignment check.







Necessary preliminary tasks:
- Remove front wheel







IMPORTANT:
Do not release track rod end from swivel bearing with impact tool.
Rubber boot of track rod end must not be damaged.







Release nut (1); if necessary, grip at Torx socket.
Remove track rod end (2) from swivel bearing.

Installation note:
Keep track rod end to swivel bearing connection clean and free from oil and grease.
Replace self-locking nut.
Tightening torque 32 21 3AZ.







Determine dimension (A) to simplify following adjustment of front axle.
Slacken bolt (1).
Screw off track rod end; if necessary, grip track rod with open-end spanner.

Installation note:
Check gaiter for damage, replace if necessary.
Screw track rod end onto track rod to dimension (A).
Tightening torque 32 21 2AZ.







After installation:
- Perform chassis / wheel alignment check