Integrated Universal Remote Control

Integrated Universal Remote Control




The integrated universal remote control replaces up to three hand held transmitters for various devices,(e.g. garage door/gate openers, alarm systems or house lighting systems).

It recognizes and "learns" the signal transmitted by each individual original hand held transmitter

The signal of an original hand held transmitter can be programmed to one of the three channel buttons. The device is operated with the programmed channel button. The integrated universal remote control uses radio frequencies only (not infrared). Transmission of the signal is indicated by the indicator LED.

During the programming procedure and prior to remote activation of a programmed device it is important to ensure that no persons, animals or objects are located within the range of the device in question (e.g. garage door) as a precaution against injury. The safety precautions for the original hand transmitter must also be complied with.

Original transmitter




If the symbol depicted to the right is on the packaging or in the instructions of the original hand held transmitter, it may be assumed that this original transmitter is compatible with the integrated universal remote control.

Check for random code

The instructions of the original hand held transmitter describe whether or not the original hand transmitter is equipped with a random code system.

Alternatively, a channel button can be programmed to carry out this check. Hold down the programmed channel button on the integrated universal remote control.

If the indicator lamp on the integrated universal remote control flashes quickly for two seconds and then stays on, this means that the original hand transmitter is equipped with a random code system and that the channel buttons can be programmed accordingly.

Programming the integrated universal remote control




To program a channel button with the signal of the original hand transmitter, proceed as follows:

1. Ignition lock position (terminal 15).
2. For initial operation, proceed as follows: press the two outer buttons (1) until the indicator lamp (on the left of the program button) begins to flash, then release the buttons. The three channel buttons are cancelled.
3. Hold the original transmitter max.5 cm (2 in) away from the channel buttons.
4. At the same time, press the transmit button on the original transmitter and the desired channel button on the integrated universal remote control. Release both buttons when the indicator lamp begins to flash quickly.
5. To program additional transmitters, repeat steps 3 and 4.

Programming a random code

To use the integrated universal remote control with a random code system, additional programming steps are necessary. A second person simplifies the programming procedure.

1. Program the integrated universal remote control as described previously.
2. Hold down the programming button on the device receiver for approx. two seconds until the programming lamps on the device come on.
3. Press the desired channel button on the integrated universal remote control three times.

Frequency range

The system operates in the frequency bands 27-40 MHz and 433.2 MHz. Faults and malfunctions may be attributed to radio waves emitted by other transmitters at these frequencies.