Removing and Installing/Replacing Airbag Module on Passenger Side

72 12 000 - Removing and installing or replacing airbag module on passenger side





Warning!
Read and comply with [1][2]Safety Regulations for Handling Components with Gas Generators safety regulations for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.

Follow instructions for disconnecting and connecting battery Instructions for Disconnecting and Connecting Battery!





Necessary preliminary tasks:
- Disconnect negative battery cable Disconnecting and Connecting Battery Negative Lead

- Remove glovebox

Version with CD changer:
- Remove Removing and Installing/Replacing CD Changer CD changer





Unfasten plug connection (3) and disconnect.
Release screws (4).
Lay retaining clip (2) slightly to one side.

Important!
Airbag module (1) could fall out after screws (5) have been released. Grip airbag module (1) firmly.

Release screws (5) and carefully remove airbag module (1).





Installation Note:
When inserting airbag module (4) in channel (3), make sure channel (3) rests all round airbag module (4). If necessary, pull channel (3) apart at sides.
Replace screws (1).
Retainers (2) fall out during removal and do not have to be replaced.
Tightening torque: 72 12 02AZ Airbag Modules.





If necessary, retrofit protective cover when replacing airbag module:
New airbag module is supplied with a protective cover.
Release screws in marked area.
Tightening torque: 72 12 05AZ Airbag Modules.
Remove mounting frame (1).





Place protective cover (1) over studs.
Straight side points to air duct (2).